top of the range for small, medium and large needs

Series COPCAL KDS "Small dryers"

Dryers suitable for small needs.

Supplied already assembled complete with heat generator and ready for operation with loading capacity from 5 to 15 m3.

  • Final humidity up to 5%;
  • Prefabricated AISI/304 stainless steel structure;
  • Polyurethane or high density mineral wool insulation;
  • Heating using hot or over-heated water, steam or diathermic oil, or by means of direct natural gas/propane heating;
  • Electrical equipment for ventilation, heating, humidification and ejection;
  • Loading by means of trucks on rails, pallet trucks, or small lift trucks;
  • Automatic Dryer-wood process control.


Series COPCAL HT & HTT "Traditional dryers"

Traditional dryers suitable for medium and large needs.

Conventional heat dryers that use water, overheated water, vapour or diathermic oil systems or indirect heating systems with gas operated air/fumes exchangers to generate heat. Our dryers are built with load bearing structure in AISI/304 stainless steel sized to resist to the high mechanical stress to which the system may be subjected.


  • COPCAL HT is the traditional dryer with fork-lift truck front loading;
  • COPCAL HTT is a tunnel dryer that uses a loading system with trolleys on rails. This solution is particularly suitable for drying large quantities of softwoods. The doors can be one or two, one for loading and one for unloading. This solution in some cases increases the efficiency of the drying plant;
  • Loading capacity from 20 to 200 m3 per drying cycle;
  • Final humidity up to 5%;
  • Load-bearing structure in AISI/304 stainless steel, or alternatively in masonry, to be constructed by the client;
  • Polyurethane or high density mineral wool insulation;
  • Heating using hot water, steam or diathermic oil, or by means of direct natural gas/propane heating;
  • Electrical equipment for ventilation, heating, humidification and ejection;
  • Loading by means of front fork lift trucks, or with trolleys on rails;
  • Automatic Dryer-wood process control;


Series COPCAL PRD "Pre-dryers"

Suitable for large needs.

These guarantee ideal temperature and humidity conditions for the storage of large amounts of wood. The wood is dried at low temperatures and high relative humidity levels up to 25-30% of the fibre saturation point, preserving the wood's qualitative characteristics and reducing stress and tension.


  • Load-bearing structure in steel or alternatively in masonry;
  • Loading by means of front fork lift trucks;
  • Zone climate control;
  • Automatic Dryer-wood process control;
  • Heat generated by hot water using heat exchangers;
  • Air humidification and dehumidification systems;
  • Design of made-to-measure systems.